Sustainable Marine Structures

Constructal Design Applied to an Overtopping Wave Energy Converter Locate on Paraná Coast in Brazil

Sthefany Amaral da Silva

Paranaguá Campus, Paraná Federal Institute of Education, Science and Technology (IFPR), Paranaguá, 83215-750, PR, Brazil.

Jaifer Corrêa Martins

School of Engineering, Federal University of Rio Grande (FURG), Rio Grande, 96201-900, RS, Brazil.

Elizaldo Domingues dos Santos

School of Engineering, Federal University of Rio Grande (FURG), Rio Grande, 96201-900, RS, Brazil.

Luiz Alberto Oliveira Rocha

School of Engineering, Federal University of Rio Grande (FURG), Rio Grande, 96201-900, RS, Brazil.

Bianca Neves Machado

Interdisciplinary Department, Federal University of Rio Grande do Sul (UFRGS), Tramandaí, 95590-000, RS, Brazil.

Liércio André Isoldi

School of Engineering, Federal University of Rio Grande (FURG), Rio Grande, 96201-900, RS, Brazil.

Mateus das Neves Gomes

Instituto Federal do Paraná

DOI: https://doi.org/10.36956/sms.v6i2.1113

Received: 24 May 2024; Published: 5 September 2024

Abstract

This research aims a numerical and geometrical investigation about an Overtopping Device Wave Energy Converter (OTD-WEC). Constructal Design method was employed to perform a geometric evaluation of this OTD-WEC submitted to ocean waves with similar characteristics of the coastal region of Paraná State – Pontal do Paraná city in southern Brazil, located 41 km from the coast and 30 m water deep. It was analyzed two different significant wave heights, HS1 = 1.25 m and HS2 = 1.50 m. In each set, it were simulated 10 cases with different ramp angles, totaling 20 numerical simulations. The main goal was to evaluate the influence of the ramp angle on the water mass flow rate entering the reservoir. Therefore, through the Construtal Design, the degree of freedom (DOF) H1/L1 (ratio between the height and length of the ramp) was varied, considering a constant area of the ramp. For the numerical analysis, a two-dimensional computational model was employed using the commercial software Ansys Fluent, which is based on the Finite Volume Method (FVM). The multiphase Volume of Fluid (VOF) model was applied to tackle with the water-air interaction. The results showed that the best geometric configurations happened for those cases with smaller ramp angles. In addition, a reconfiguration of the ramp angles, keeping the area fixed, allowed a significant improvement in the OTD-WEC available power.

Keywords: Numerical Simulation; Geometric Analysis; Sea Wave Energy Converter; Overtopping Device; Ansys Fluent

References